Video tester family extended to meet HDMI 2.0 6G

The electrical characteristics of HDMI sources are measured to verify basic signal integrity and identify faulty circuits, insufficient port connections as well as defective cables and lines. The new base module is added by an HDMI test adapter via a high frequency cable. The measurement instrument itself can be used for eye diagram analysis and other complex measurements in line with HDMI specifications for all TMDS signals without modifying the test setup.

Another new module, the R&S VT-B2362 HDMI CTS receiver/generator function for 600 MHz, enhances the Rohde & Schwarz HDMI protocol test portfolio by adding compliance tests for the new HDMI 2.0 version. The time minimised differential signalling protocol behind the technology can now also be tested for data rates of > 340 Mcsc in line with HDMI 2.0 specifications. This option is especially useful for carrying out the HF1-10 ff source tests and the HF2-5 ff sink tests required by the new compliance test specification.

The solution targets design engineers and producers of consumer electronics equipment such as TVs, set top boxes, projectors and Blu-ray players, for chip manufacturers and test houses as well as the wide base electronics market.

The new R&S VT-B2362 module for HDMI source and sink compliance tests and the new R&S VT-B2380 module for debugging the electrical characteristics of HDMI sources are now available from Rohde & Schwarz. They are ideal for the R&S VTS, R&S VTE and R&S VTC video testers.