Test & Measurement

Eye diagrams added to serial trigger, decode solutions

26th June 2016
Mick Elliott
0

The Serial Data Analysis capabilities for Teledyne LeCroy’s oscilloscope solutions have been enhanced by Eye Diagram capabilities in the new TDME Serial Bus options. The company is offering the widest range of Trigger (T), Decode (D), Measure/Graph(M or G) and Eye Diagram and Physical Layer (E or P) options.

The user can isolate events using the serial bus trigger and view color-coded protocol information on top of analog or digital waveforms. Timing and bus measurements allow quick and easy characterisation of a serial data system. Measurement data can be graphed to monitor system performance over time.

Users can identify physical layer anomalies with eye diagram mask testing and mask failure locator. It is possible to rapidly display an eye diagram of the packetised low-speed serial data signal without additional setup time.

Eye parameters can be used to quantify system performance and apply a standard or custom mask to identify anomalies. Mask failures can be indicated and can force the scope into Stop mode.

Up to four serial data signals can be decoded and displayed as eye diagrams at one time. These can be different protocols, or the same protocol measured at different points (e.g., transmits and receive, different nodes, or different standard-defined test points).

Users can apply a user-defined filter to each eye diagram to only display specific signals in the eye.

The signal quality of physical layer can be qualified in the eye by applying parameters for Eye Height, Eye Width, and Number of Mask Failures. Some packages (e.g. FlexRay TDMP) go a step further and include additional measurements defined in the standard.

A user-defined or pre-defined mask may be added to the eye diagram so as to objectively evaluate if the physical layer signal intrudes too far into the eye opening.

Users need to apply a filter to include or exclude specific messages from the Eye so as to determine failure source (e.g., messages from a specific node or with a specific ID). Mask failures are indicated with a red circle and can be displayed in a table. Touch the failure table to open a zoom of the failed area for further inspection.

Some standards, due to their speed or nodal complexity, provide specific guidance on what eye diagrams or measurements should be made and exactly how they should be performed.

FlexRay and MIPI DPHY are examples. In these cases, the Eye Diagram (“E”) capability is augmented with additional specialized “P” capability (for Physical Layer Measurements), per the standard In these cases, the “E” capabilities previously described are also available.

Eye Diagram is available for the following standards: I2C, SPI, UART RS-232, CAN, CAN FD, FlexRay, LIN, ARINC429, MIL-STD-1553, USB 2.0, 8b/10b, LPDDR2, DDR2, DDR3;, D-PHY/CSI-2/DSI, M-PHY, NRZ

Product Spotlight

Upcoming Events

View all events
Newsletter
Latest global electronics news
© Copyright 2024 Electronic Specifier