The Brad M12 Power connectors come equipped with an F-Coding mating interface to prevent accidental usage with other M12 connectors being used for input, output, signal or industrial network connections. The robust blind-mate key design significantly reduces the chance of mis-mating, especially in restricted access locations where visibility is limited. To eliminate the chance of electrical shock, the connector pins are recessed in a contact carrier. The receptacle design has been enhanced to more efficiently dissipate heat generated by the higher current-carrying capability, while maintaining its compact size.
The 4-pin M12 connectors will accommodate wire sizes up to 14 AWG/2.5mm2 and are rated for 300VAC/DC operation with a dielectric withstanding voltage of 1600V. The operating temperature range is -20 to +90ºC. An IP67 seal interface makes the Brad M12 Power F-Coded cordsets and receptacles suitable for use in harsh and wet industrial environments. The connector is dust-proof and can be temporarily submerged in up to one metre of water.
The interconnect system offers a great advantage over the more predominant, larger and more expensive M23 and MIL-C-5015 connector interfaces. The F-Coding is planned to be adopted by the IEC Standard 61076-2-111 and has been submitted for ANSI/EIA acceptance. This will allow for an open-industry connector standard, increasing adoption among a wide array of platforms and manufacturers.
In addition to panel mount male/female receptacle cordsets, the F-Coded series includes single ended and double ended cordsets, with straight or 90º, male or female connectors.