The belt/wall clip kit consists of three moulded parts: the belt clip and mounting boss which are fitted to the enclosure, and the wall holder. The belt clip can slide out for access to the battery compartment. The enclosure must be drilled with two diameter 4.2 mm holes to fit the mounting boss. The belt clip is designed to slide into the wall holder, which can de easily mounted to a wall or inside a cabinet.
The belt/wall clip accessory is moulded in off-white, lava grey and black ABS, and can be fitted to any other plastic enclosure with a minimum wall thickness of 4 mm. If the wall thickness is less than 4 mm then a washer must be used.
The ‘SOFT-CASE’ series is available in three standard sizes from 82 x 51 x 14 mm to 117 x 73 x 24 mm. The cases are moulded off-white or lava grey ABS, or infra-red black PMMA. Three types of battery compartment are offered which will accept 2×1.5V AAA, 2×1.5V AA or 1x9V cells. The top part has a wide recessed area for locating the display or membrane keypad. Also, a raised panel on the long edge of the base part is provided for USB, power or serial connectors and controls.