Events News

Seika Machinery will exhibit the latest SMT solutions at SMTAI

17th September 2015
Jordan Mulcare

Seika Machinery will exhibit in Booth #707 at SMTA International, scheduled to take place 29th - 30th September, 2015 at the Donald Stephens Convention Centre in Rosemont, Illinois. The Seika team will be available to demonstrate the following equipment: DEN-ON INSTRUMENTS' RD-500V Rework Station, UNITECH's UC-250M-CV PCB Board Cleaner, MALCOM's SPS Solder Paste Mixer and MALCOM's Spiral Viscometer.

The RD-500V Rework Station features a 2MP full HD camera with a 19" LCD display for easy visual alignment. It samples the data in very small intervals of 0.1s, allowing extremely accurate temperature control. The RD-500V is equipped with powerful built-in 1,000W heaters on both the top- and bottom-side and an area heater that includes six quick heating 600W IR heaters. Precise profiling including detailed temperature curves can be executed with the ability to closely control up to 30 zones.

The UC-250M-CV Board Cleaner adds a dual cleaning feature using a combination of a brush roller with the silicone/adhesive cleaning rollers. The combination dual dust removal system assures better results than a single brush or adhesive roller system. The UC-250M-CV has the ability to clean the top surface of PCB even chip components attached on the bottom side. Additionally, the cleaner features an antistatic bar (ioniser) to neutralise static and prevent dust from collecting on the top surface of the PCB.

The MALCOM SPS Solder Paste Mixer is a non-contaminating mixer that utilises pseudo planetary motion to stir the solder paste. The SPS-1 provides uniform paste consistency regardless of operator skill. The paste temperature rises due to friction, enabling control over the solder paste viscosity. Now, a solder paste can be pulled from the refrigerator and ready on the stencil, in 10 minutes.

The MALCOM PCU-200 Digital Viscometer features a patented spiral-pump sensor that provides quick, easy and repeatable measurements. It provides continuous measurement of newtonian and non-newtonian fluids with constant shear rate and shear time. Additionally, the system features automatic control of measurement according to JIS standards (PCU-203,205). Application includes solder pastes, thick film pastes, solder resists, liquid resists and inks.

Also at the show, company representatives will highlight the MALCOM RCX-1 Reflow Monitoring System and Hioki Flying Probe among other equipment.

Featured products

Upcoming Events

View all events
Latest global electronics news