The motors are also equipped with alarm and torque monitoring functions for safe operation and control, the company state. The design also includes a torque control function for winding applications, which acts in a similar way to an electronic clutch. Electromechanical brake options are also available.
The speed or torque can be adjusted via an analogue output and/or the user can set 16 programmable speeds, depending on the required motion profile requirements.
Snap-on, IP-rated motor connectors, where the user can select lengths of cable, from 1-20m, allow an appropriate length to be specified.
The motors use an EURONORM X 10 CrNiS18 9 stainless steel shaft and there is a varied selection of gear types, including spur gear, hollow shaft gear and foot mounted options.
The BLE2 motor and driver can be programmed using the free-of-charge software MEXE02 suite. Set-up can be via a PC using the software or via a programmable logic controller. The software can be used for troubleshooting and to make maintenance, fault finding and setup easier.
