Temperature measurement IC linearises sensors to 0.1°C conformity

Posted By : Daisy Stapley-Bunten
Temperature measurement IC linearises sensors to 0.1°C conformity

The LTC2986 high performance digital temperature measurement IC, which directly digitises any combination of thermocouples, RTDs, thermistors and external diodes with 0.1°C conformity and 0.001°C resolution has been introduced by Linear Technology. The LTC2986 builds on the award-winning LTC2983 and LTC2984 by adding three new operating modes and reducing the number of analogue inputs from 20 channels to 10 channels.

The new operating modes provide better support for external overvoltage protection resistors that are shared between multiple sensor types, powered temperature sensors with analogue outputs, and other non-temperature related sensors such as pressure or other voltage output sensors.

The LTC2986’s high performance analogue front end combines low noise and low offset buffered ADCs with all the necessary excitation and control circuits for each sensor. Measurements are performed under the control of a digital engine, combining all the algorithms and linearisation required for each. The device precisely measures absolute microvolt level signals from thermocouples and ratiometric resistance measurements from RTDs and thermistors, performs the linearisation and outputs the results in °C or °F. Up to ten analogue inputs are available, allowing support for up to nine thermocouples, four RTDs, four thermistors and/or ten diodes. The SPI interface works with virtually any digital system and a comprehensive software support system with drop-down menus allows easy customisation of the LTC2986.

The simple, yet feature-rich, LTC2986 interfaces with a wide variety of temperature sensors, including type B, E, J, K, N, S, R, T thermocouples, 2-, 3- or 4-wire RTDs, 2.25kΩ to 30kΩ thermistors and temperature sensing diodes. The LTC2986 works with ground-referenced sensors without the need of amplifiers, negative supplies or level shift circuitry. Signals are simultaneously digitised with three, high accuracy, 24-bit Δ∑ ADCs using an internal 15ppm/°C reference. Automatic thermocouple cold junction compensation is accomplished using any type of external sensor. Included on the chip are linearisation algorithms for all common sensor types. Custom sensors can be linearized with custom coefficients, programmed and stored in the chip. Onboard EEPROM (LTC2986-1) is used to store user configuration data and custom sensor coefficients, eliminating any IC or sensor programming by a host processor. Dual programmable excitation current sources feature current reversal and current ranging to improve accuracy and reduce noise. To ensure resistive measurements are accurate, current reversal eliminates thermocouple effects in the resistive sensor. Sensor-specific fault detection alerts the user of short-circuits, open-circuits, overtemperature, undertemperature and ADC overranging.

The LTC2986 is offered in commercial, industrial and automotive versions, supporting operating temperature ranges from 0 to +70°C, -40 to +85°C and respectively, -40 to +125°C. The LTC2986 is now available in a RoHS compliant, 7x7mm LQFP-48 package, and is pin-compatible with the LTC2983 and LTC2984. Pricing starts at $16.56 each in 1,000 piece quantities.

Downloads


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

Girls in Tech | Catalyst | 2019
4th September 2019
United Kingdom The Brewery, London
DSEI 2019
10th September 2019
United Kingdom EXCEL, London
EMO Hannover 2019
16th September 2019
Germany Hannover
Women in Tech Festival 2019
17th September 2019
United Kingdom The Brewery, London
European Microwave Week 2019
29th September 2019
France Porte De Versailles Paris