New capabilities enhance emulators/analysers

12th April 2016
Posted By : Mick Elliott
New capabilities enhance emulators/analysers

Enhanced T1 E1 analyser products and software have been announced by GL Communications. CEO Vijay Kulkarni said, "Our T1 E1 Analysis suite of products continues to provide the most comprehensive analysis and emulation capability of any product on the market.  Any traffic over T1 E1 lines including voice, fax, modem, signalling, mobile, IP, VoIP, ATM, and more is addressed."

He explained, “Our newly introduced MAPS APS is a high capacity Analog 2-wire Bulk Call Generator used to test a Central Office (CO), PBX, ATAs, Gateway or other telecommunications equipment, which provide local loop interfaces. It supports up to 192 independent FXO ports per 1U MAPS APS Server (includes 1 Octal T1 card) and multiple APSCB-48 units. More can be achieved by simply scaling the system with a 4U MAPS APS Server (includes 2 Octal T1 Cards) and proportionately add more APSCB-48 units to support up to 384 analogue ports.”

Physical Layer Analysis is a new T1 E1 protocol analyser and it is now a part of Special Applications. It will monitor physical layer alarms such as Sync Loss, Carrier Loss, Blue Alarm, Yellow Alarm, AIS, and Error Counters such as Frequency (Hz), Level (dBdsx) for every specified Time Period in Seconds on the selected T1 E1 Port.

Also announced were enhancements to existing products. The T1 E1 Error Insertion applications’ maximum error insertion rate for logic errors has been increased from 0.01 to 1.0.

WCS task commands now check for successful task thread creation, rather than just assuming success. If the task thread cannot be created, the command is negatively acknowledged (NAK).

The enhanced Multichannel Audio-Bridge application now comes with channel configuration option that is provided as Drop Down menu. Default channel configuration is set to Mono. This can be changed to Stereo with Left and Right Channels.

Now support for Linear 16 bit PCM, 16k codec is also added. Stream Selection configuration option has been removed and the same is moved to the main GUI.  Each device entry can be dynamically configured as Insert or Drop device.  

For INSERT action, only Mono mode option is provided.  Additionally, the Audio-Monitor window now includes maximise, resize and scrolling options.

There are also significant enhancements introduced to Protocol Analysers and MAPS-based Protocol Emulators functions.


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

Girls in Tech | Catalyst | 2019
4th September 2019
United Kingdom The Brewery, London
DSEI 2019
10th September 2019
United Kingdom EXCEL, London
EMO Hannover 2019
16th September 2019
Germany Hannover
Women in Tech Festival 2019
17th September 2019
United Kingdom The Brewery, London
European Microwave Week 2019
29th September 2019
France Porte De Versailles Paris