Optoelectronics

Optical sensors enable short-wave blue LED lighting

14th March 2018
Lanna Deamer
0

A minimal sensor area of only 1.9x3.3mm is sufficient for the optical sensors in the iC-PNH series to scan encoder code discs and generate sine signals in top hi-fi quality. Evaluation is executed by interpolation ICs using a Nonius calculation, e.g. iC-MN and iC-MNF, permitting a very high angle resolution of more than 21 bits, even with code disc diameters of only 26mm. All devices of this series can be used with short-wave blue LED lighting for an high accuracy due to a sharper projection.

Compared with conventional absolute encoder sensors, iC-PNH sensors do only scan three incremental Nonius tracks and one 2-bit Gray code, saving on assembly space and simplifying illumination.

The smaller scanning surface and the high sensitivity of the sensors help to reduce the amount of power needed for the obligatory LED, what is proving beneficial to the LED's expected life time. The phased arrays can be used with a blue LED, e.g. iC-TL46, which minimises distortion and increases the signal contrast. The encoder-typical IR-LED (e.g. iC-TL85) can also be used.

The photocurrent signals are converted into low impedance and interference-resistant output voltages by low noise amplifiers. Depending on the selected chip, a high transimpedance gain of typical 1MW means that at an illumination level between 3-6mW/cm2 signal voltages of several hundred millivolts are available at the outputs for the subsequent interpolation device.

iC-PNH devices are available for code discs of 26, 33, and 39mm diameters and operate with a supply voltage of 4.1V within a temperature range of -40 to +125 °C. With a maximum thickness of 0.9mm, its flat optoQFN package is saving on valuable board space due to the edge length of only 5x5mm.

iC-PNH is typically deployed as Nonius-based absolute position encoders. As with a Vernier caliper which scale was introduced by the French mathematician Pierre Vernier in the 17th century, the accuracy of reading is increased due to multiple scales, with the absolute position information contained in the relative phase shift between the signals.

With an interpolation resolution of 14 bit, the new encoder interpolator iC-MNF is capable of this special kind of evaluation. This 2-chip system not only reduces system costs but also presents a small form factor alternative to position encoders, opening up new areas in the field of applications.

In each channel, iC-MNF has a separately adjustable signal conditioning unit with a sample-and-hold stage that captures the conditioned analogue signal for the ensuing sequential digitisation process. For this, a high precision SAR A/D converter is provided which has an adjustable interpolation resolution of up to 14 bits. The non-linear A/D converter makes use of the tangent function and analyses the sine and cosine simultaneously.

In order to compute the high resolution angle positions, 2- and 3-track-Nonius calculations can be configured which enable resolutions of up to 25 bits (0.04 arc seconds from 360°).

The converter IC which measures only 7x7mm in QFN48, is protected at the cable end against reverse polarity and incorrect connections and contains the RS422 transceiver for the serial data interface. Data is output in a SSI or BiSS protocol at clock rates of up to 10Mbit/s.

All of the main functions of the chip are monitored and can be configured for alarm indication. Typical sensor errors, such as loss of signal due to wire breakage, short circuiting, dirt, or aging, for example, are recognised and signaled to the controller.

Product Spotlight

Upcoming Events

View all events
Newsletter
Latest global electronics news
© Copyright 2024 Electronic Specifier