H-bridge motor driver with current sense output

17th May 2019
Posted By : Alex Lynn
H-bridge motor driver with current sense output

The DRV8873 device from Texas Instruments is an integrated driver IC for driving a brushed DC motor in industrial applications. Two logic inputs control the H-bridge driver, which consists of four N-channel MOSFETs that drive motors bi-directionally with up to ten amp peak current. The device operates from a single power supply and supports a wide input supply range from 4.5 to 38V.

A PH/EN or PWM interface allows simple interfacing to controller circuits. Alternatively, independent half-bridge control is available to drive two solenoid loads.

A current mirror allows the controller to monitor the load current. This mirror approximates the current through the high-side FETs, and does not require a high-power resistor for sensing the current.

A low-power sleep mode is provided to achieve very-low quiescent current draw by shutting down much of the internal circuitry. Internal protection functions are provided for undervoltage lockout, charge pump faults, overcurrent protection, short-circuit protection, open-load detection, and overtemperature. Fault conditions are indicated on an nFAULT pin and through the SPI registers.

To learn more, click here.


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

Sensor+Test 2019
25th June 2019
Germany Nürnberg Messe
The Digital Healthcare Show 2019
26th June 2019
United Kingdom EXCEL, London
unbound london 2019
17th July 2019
United Kingdom Old Truman Brewery, London
DSEI 2019
10th September 2019
United Kingdom EXCEL, London
EMO Hannover 2019
16th September 2019
Germany Hannover