LPRS introduce industrial-use DSSS true diversity radio transceiver modem for applications in the U.S.A.
LPRS, Europe’s leading supplier of short-range radio devices, announces the introduction of the Circuit Design MU-D1-R 915 MHz, embedded low power radio transceiver modem for industrial use that complies with U.S. FCC Part 15.247.The
In addition to using highly noise-resistant direct-sequence spread spectrum (DSSS) modulation, the modem has a true diversity receiver function with two receiver circuits for preventing signal dropout due to multi-path fading. This ensures highly stable and reliable radio communication in the congested 902 to 928 MHz ISM band which is used by many types of wireless controlled equipment.
With 20 frequency channels available it can be used in many wireless systems. The modem operates at low power, 55mA/8mW when transmitting and 58mA when receiving and with its small size, 36 x 26 x 8mm it can be built into units that require battery operation.
John Sharples, Managing Director of LPRS comments:”The new MU-D1-R transceiver from Circuit Design is a highly reliable, industrial use modem. Using direct sequence spread spectrum for superior noise resistance instead of simple antenna switching type diversity, the modem uses a true diversity receiver circuit with two built-in receiver circuits.”
In addition to the CDP series transmitter and receiver modules and STD/LMD series transceiver modules which are highly regarded in the European and Japanese markets, Circuit Design offers the MU-D1-R series radio modem with a built-in wireless protocol to enable the input/output of data with simple commands. With its built-in CPU, the MU series performs wireless-specific high frequency control for UART communication with an external microcomputer. As a result system development times are significantly shortened and component numbers reduced. In addition, the built-in protocols make networking simple for applications that require reliability and real time control such as industrial remote control. The MU-D1-R is expected to be used in a wide range of low power industrial applications such as monitoring systems where battery operation is required.
Key features of the MU-D1-R include a wide operating temperature range of -20 to +65ºC, built in TCXO and all high frequency circuits are enclosed inside the shielded case. Operating voltage is 4 – 5.5 VDC with low power operation enabling systems to run for long periods from battery power. Compliant with FCC Part 15.247, frequency range 905.5 to 924.5 MHz, 20 channels, output switchable between 8 and 40mW, data rate 40 kbps (interface), 600 kbps (wireless 40 kbps x 15 chips), size 36 × 26 × 8 m and weight 13g
1st March 2013
Caravan Alarm System Controlled by LPRS Wireless Keyfob and Receiver Module
15th November 2012
ADLINK Technology Announces Latest Industrial Mobile Handheld Device
19th December 2011
Fairchild Semiconductor’s Digital Microphone Series Converts ECM Outputs to Digital PDM Data Streams, and includes Temperature Compensation
13th October 2011
Hand held terminals optimised for retail and industrial applications
27th September 2011
Toshiba Launches Wireless IC Compliant with TransferJetTM Close Proximity Wireless Transfer Technology
16th September 2011
TI introduces the industry’s smallest High-Speed USB protection device for portable applications