Precision bar clamps for press-pack semiconductors

19th September 2013
Source: IXYS
Posted By : Nat Bowers
Precision bar clamps for press-pack semiconductors

IXYS has today announced that its wholly owned UK subsidiary, IXYS UK Westcode, has launched its new range of precision bar clamps for use with its comprehensive range of press-pack semiconductors. These clamps have been specifically designed for use with IXYS UK diode and thyristor press-pack capsule devices with poleface diameters from 19mm up to 75mm.

This range is available with clamp forces from 900kgf (9kN) to 5000kgf (50kN) and has a maximum height allowance of up to 120mm to accommodate busbar and cooling arrangements. These clamps can be used for both single side and double side cooling.

Each clamp in the range has a single, high accuracy, calibrated force which applies a constant pressure to the press-pack device and is simple to install. A two-rod system is used with Belleville washers to give even clamping force on the device.

“This range of precision bar clamps, specifically designed to suit the IXYS UK range of press-pack semiconductor devices, fills the gap in our range of complementary products. Each product in the range is pre-calibrated and designed for simple, no-hassle installation without the need for specialist tools or torque wrenches. This range further enables IXYS UK to provide a total solution to our customers,” commented Nicholas Tarling, Product Engineer at IXYS UK.


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

Startups Magazine Launch Party: Financing a Startup
24th July 2018
United Kingdom WeWork Waterhouse Square, London
European Microwave Week 2018
23rd September 2018
Spain Ifema Feria De Madrid
IoT Solutions World Congress 2018
16th October 2018
Spain Barcelona
Engineering Design Show 2018
17th October 2018
United Kingdom Ricoh Arena, Coventry
Maintec 2018
6th November 2018
United Kingdom NEC, Birmingham