Build an open source MCU and programme it with Arduino

14th July 2017
Posted By : Lanna Cooper
Build an open source MCU and programme it with Arduino

 

Configuring the low cost Arty FPGA board with an Arduino compatible RISC-V platform.

In this post we take a look at how the eminently affordable Xilinx Artix-7 based Digilent Arty Board - which was designed with makers and hobbyists in mind - can be configured with an open source RISC-V microcontroller that can optionally be built from RTL sources, and which can then be programmed via the Arduino IDE or alternatively a makefile driven GNU toolchain.

Basic familiarity with Linux, git and makefile driven software build is assumed.

Click here to read the full article.


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

Imagineering Fair at Bath & West Show
30th May 2018
United Kingdom The Royal Bath & West Society Showground, Somerset
PCIM 2018
5th June 2018
Germany Nuremberg
Developing secure and scalable IoT solutions
21st June 2018
United Kingdom Cocoon Networks, London
SENSOR+TEST 2018
26th June 2018
Germany Nürnberg Exhibition Centre
European Microwave Week 2018
23rd September 2018
Spain Ifema Feria De Madrid