Ruggedised 19in. subrack offers enhanced shock and vibration resistance

A standard subrack consists of two side panels and at least four horizontal rails. By using stronger side panels, reinforced horizontal rails, 19in. brackets and corner profiles, the new subrack is able to achieve a shock resistance up to 25 g.

Standard guide rails can be used in the ruggedised subrack, and where necessary these can be bolted to the horizontal rails. There are also ductings to accept Card-Loks or clamshells in 0.8in. intervals, and special cover plates reduce noise caused by vibration.

All front surfaces of the subrack parts are anodised, giving a functional, scratch-resistant and visually attractive finish. Yellow chromated finishes are also available on request.

Available in heights from 3 to 12U and widths from 21 to 84HP, the europacPRO subracks are designed to satisfy the requirements of IEC 60297-3-100 to IEC 60297-3-105 and IEEE 1101.1, 1101.10 and 1101.11. They can be supplied in kit form or fully assembled by Schroff’s expert technicians, and there are no minimum order quantities.