Laboratory power supply offers flexible 1.2 kW output
News Release from:
Thurlby Thandar Instruments Ltd
21 October 2011
Aim-TTi has introduced a lower-cost version of the company's best-selling QPX1200 series laboratory power supply. The new model is designated QPX1200S and is intended for applications where digital remote control is not needed.
The QPX1200S has a maximum power of 1200 W and features PowerFlex regulation. This enables it to offer voltage and current combinations between 60 V / 20 A and 20 V / 50 A, making it suitable for a very wide range of applications.
A linear output stage is included within the PowerFlex regulator. This gives it a low output noise of less than 3 mV RMS and a transient recovery time typically ten times better than that of conventional switch-mode units.
Setting of voltage and current is fully digitally controlled via keypad or “spin wheel” controls using instrumentation-quality 16-bit digital/analogue converters. A quasi-analogue interface is also included which provides zero to full-scale voltage or current from 0 to 5 V or 0 to 10 V inputs.
An unusual feature of the QPX1200S is its ability to directly measure low resistance by calculating the voltage/current ratio. This enables very low impedances to be measured at high currents, eliminating the potential thermal EMF errors inherent in low-current measurements.
Unlike many higher-power laboratory power supplies, the QPX1200S is suited to bench or rack-mount applications. Output and sense terminals are provided on both the front and rear panels. The case has integral tilt feet, and a 3U rack mount is available as an option.