ON Semiconductor unveils the NCP6924 and NCP6914 power management ICs
News Release from:
01 October 2012
ON Semiconductor has unveiled two new power management integrated circuits optimised for battery powered systems such as smartphones, tablets, digital cameras, GPS systems and other portable electronics. Utilising the latest power management techniques, the NCP6924 and NCP6914 optimise system efficiency and save battery life.
The NCP6924 integrates two high efficiency 800 milliamp (mA), 3 megahertz step down DC-DC converters and four low dropout voltage regulators for a total quiescent current of just 105 microamps (µA). The NCP6914 integrates a single high efficiency 800 mA, 3 MHz step down DC- DC converter and four LDO regulators to deliver a low quiescent current of just 72 µA. Featuring five and six voltage rails, both of these devices are perfectly sized to supply power to mixed signal modules such as cameras, or to complement power distribution to an application processor under minimum supervision.
“As part of ON Semiconductor’s expanding family of ultra small PMICs, the NCP6924 and NCP6914 offer design engineers flexibility and performance, making them an ideal solution in power distribution for portable applications,” said Thibault Kassir, director of ON Semiconductor’s Interface and Power products. “Both devices save on-board real estate by providing multiple strings of power distribution and allowing higher power densities to be distributed across the system, helping to solve thermal challenges.”
Programming flexibility is offered through a 400 kHz/3.4 MHz I²C interface which controls power up sequencing, enables and disables output power and controls individual active output discharges. Dynamic Voltage Scaling of the DC-DC converters allows the system to adjust core or IO voltages to load profiles when, for instance, the system goes into sleep mode. In addition, the on-board LDO regulators can be directly supplied by one of the integrated DC-DC converters, considerably reducing overall power losses.
The DC-DC converters’ output voltage can be programmed from 0.6 volts to 3.3 V in 12.5 millivolts steps and LDO regulators from 1.0 V to 3.3 V in 50 mV steps. Dedicated pins and registers for power good and interrupt complete the feature set, providing the necessary supervision to report power failure.